Initial Installation
QUALIFIED INSTALLERS ONLY
Kit Contents:
Quantity | Description | Quantity | Description |
|
|
|
|
1 | Fan Assembly | 1 | Power Cord - 6ft (1.8m) |
|
|
|
|
1 | Wiring Harness | 1 | Star Washer |
|
|
|
|
1 | Temperature Sensor | 1 | |
|
|
|
|
1 | Fan Control; 3 Position Switch |
|
|
|
|
|
|
Please ensure that all components are supplied with this kit. If components are missing or have been damaged, contact your dealer, distributor or courier company before starting this installation.
Fan Kit Installation:
1.Use a flat head screwdriver or 1⁄4” socket to remove the nine (9) screws holding the back cover on (see Figure 47).
2.Insert the power cord through the plastic bushing in the left cabinet side (refer to Figure 48), place the strain around the cord approximately 3” (76 mm) from the end, and insert into the fan mounting bracket with pliers (refer to Figure 49).
3.Ensure the wiring harness assembled according to Figure 45 and is attached to the fan.
Power Cord |
Plastic Bushing |
Strain Relief |
Figure 48: Installing Power Cord.
Strain Relief |
Power Cord |
Fan Mounting |
Bracket |
Figure 49: Installing Power Cord & Strain Relief.
Figure 47: Removing Back Plate From Sonnet.
4.Hold the back panel close to the left side of the unit and hook the two (2) slots on the fan bracket over the rubber grommets found on the inside of the back panel (see Figure 50).
5.Ground the power cord to the unit using a star washer and
6.Slide the fan switch and temperature sensor part of the wiring harness under the firebox to the front of the unit.
7.
Figure 50: Installing Fan onto Back Panel.
25
