Viewing Lamp Usage and Other Information

Use the Info menu to view information about the display settings of your computer and the number of hours the lamp has been used.

Press the Menu button and highlight the Info menu.

You see the lamp usage hours and various input signal settings on the right.

The life span of the lamp is about 2000 hours if the Brightness Control setting in the Setting menu is set to High (default), and 3000 hours if the Brightness Control setting is set to Low. Make sure you have a spare lamp handy if the usage hours on this menu are close to the life span of your lamp.

Solving Projector Operation Problems

The power doesn’t turn on.

If the projector doesn’t turn on when you press the PPower button, make sure the power cable is connected to the projector and plugged into a working electrical outlet.

The power cable may be defective. Disconnect the cable from the outlet and contact Epson as described on page 168.

Check to see if the A/V Mute Slide is closed.

The buttons on the projector don’t work.

If the Operation Lock function has been enabled, you can’t use the buttons on the projector. Try using the remote control instead. See page 126 for information about the Operation Lock function.

You hear the projector’s fan after the power has been turned off.

If Standby Mode is set to Network On, the fans continue to operate after the projector has cooled down. See page 128 for more information about this setting.

note

The information displayed depends on the input signal currently selected.

Solving Problems 157