Removing the Wireless 802.11g/b/a Module
Follow these steps to remove the module from your projector.
1.If you’re running NS Connection, click Disconnect on the control bar.
Click
Disconnect
2.Check the access light to make sure it isn’t flashing.
3.If you installed the security screw, remove it. Then pull the module off of the projector.
Connecting to a Wired Network
With the optional Ethernet unit, you can connect the projector to your network and configure it with an IP address.
1.Remove the wireless module, as described above, then insert the Ethernet unit into the projector.
caution
Never remove the module while the indicator light is green or when projecting wirelessly. You may damage the module or lose data.
Presenting Through a Wireless Network 89