Epson 1EMP-S1 manual f Lamp replacement period, f Replacing the lamp, BOpen the lamp cover

Appendices > Projector Care

f Lamp replacement period

•It is time to change the lamp when the "Replace Lamp" message appears in the bottom left hand corner of the screen at the commencement of projection and remains for 30 seconds.

•It is also time to change the lamp when the Warning indicator flashes red at 0.5 second intervals.

•The replacement message will appear after about 1900 hours of p use.

•When this message is displayed, please replace the lamp as quickly as possible.

•The lamp may explode if you continue to use it beyond the lamp replacement period.

•Some lamps may stop operating before the replacement message is displayed. It is recommended that you have a replacement lamp ready in case this happens.

•Replacement lamps can be purchased at your nearest dealer.

EMP-S1 User’s Guide 56

f Replacing the lamp

• Wait until the lamp has cooled down sufficiently before c opening the lamp cover. It takes a further one hour after the

cool-down period has finished for the lamp to be cool enough.

•When the lamp is broken, replace it with a new lamp, or contact your dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass.

ATurn off the projector and wait for the cool-down period to end. (Approx. 20 seconds)

Remove the power cable and wait for the lamp to cool down. (Approx. 1 hour)

BOpen the lamp cover.

Put your finger into the recess in the lamp cover hook, and lift up the air filter to remove it.