Epson 1EMP-S1 manual f Only part of the image is displayed large/small, Zoom P.30

Troubleshooting > When You Suspect a ProblemEMP-S1 User’s Guide

f Only part of the image is displayed (large/small)

• Change the resolution for the laptop	Change the resolution so that the image is displayed in the whole of the
computer or computer with a LCD screen.	projection area, or set the image signal to external output only.
	s "Selecting the Input Source" P.26
• Is the aspect ratio set correctly?	Press the [Aspect] button to set the aspect ratio to 4:3. s "Projecting in
	widescreen (changing aspect ratio)" P.29
• Has the computer been set for dual display?	If dual display has been activated in the Display Properties of the
	connected computer's Control Panel, the projector will only display about
	half of the image on the computer screen. To display the whole of the
	image on the computer screen, turn off the dual display setting. Refer to
	the video driver manual for the computer's monitor for further details.
• Has the correct resolution been selected?	Set the computer so that the signals that are output are compatible with
	this projector. Please refer to your computer's documentation for further
	details. s "Supported Display Resolutions" P.66
• Has the "Position" been adjusted correctly?	Use the "Setting" → "Screen" → "Position" configuration menu to
	correctly adjust the display position. s "Setting menu" P.38
• Is the E-Zoom function being used to	Press the [Esc] button on the remote control to cancel E-Zoom. s "E-
enlarge the image?	Zoom" P.30

49