Epson 1EMP-S1 manual f Image is out of focus unclear, menu P.38, s Installation method P.10

Troubleshooting > When You Suspect a Problem EMP-S1 User’s Guide

f Image is out of focus (unclear)

47

•The image is fuzzy

•Part of the image is out of focus

•The whole image is out of focus

• Have the "Sync.g", "Trackingg" and	If the configuration menu "Image" → "Auto Setup" setting has been set to
"Position" settings been adjusted correctly?	"OFF", press the [Auto] button on the remote control to adjust these
	settings. If the images have not been correctly adjusted after pressing the
	[Auto] button and using the auto setup function, adjust the settings
	manually in their respective menus. ([Menu] button → "Image" →
	"Picture Quality" → "Tracking", "Image" → "Picture Quality" → "Sync.",
	"Setting" → "Screen" → "Position") s "Image menu" P.35 , "Setting
	menu" P.38
• Are the image signal format settings	• When a computer or Component Videog equipment is connected, select
correct?	the appropriate setting for the input source you are using, in the "Image"
	→ "Input Signal" configuration menu.
	• When Composite Videog or S-Videog equipment is connected, select
	the appropriate setting for the video system you are using in the
	"Setting" → "Video Signal." configuration menu.
• Is the projector positioned at right angles to	s "Installation method" P.10
the screen?
• Is the projector at the correct distance from	The optimum range for projection is 87-1109cm (2.9-36.4ft.). Set the
the screen?	projector within this range. s "Installation method" P.10
• Are the front feet set so that the image	If the image angle is too big the image will be out of focus vertically.
angle is too big for the screen?	s "Adjusting the projection angle" P.24
• Is the lens dirty?	s "Cleaning the lens" P.53
• Has condensation formed on the lens?	If the projector is suddenly taken from a cold environment to a warm
	environment, condensation may form on the surface of the lens, and this
	may cause the images to appear fuzzy. Set the projector up in the room in
	which it is to be used approximately one hour before use. If condensation
	forms on the lens, turn off the power and wait for the condensation to
	disappear.
• Has the focus been correctly adjusted?	s "Adjusting the Display" P.23
• Is the lens cover still in place?	s "Turning on the Projector" P.20