Caution

If you do not align the cable connectors correctly, you could severely damage your drive when you push them in.

5.If you installed a hard disk drive in one of the external bays, replace the faceplate. Insert one side of the plate, then

gently press on the other side until it snaps into place.

If you installed a diskette drive in the bay, it is drive B; the drive installed in the mounting bracket is A. You can change the drive assignments through SETUP.

If you have one hard disk drive installed in the bracket below the diskette drive and a second hard disk drive in the bay, you will need to purchase a new hard disk drive cable that can reach both drives.

After you have completed installation of the drive in the external bay, you must replace the mounting bracket which contains the diskette drive (and possibly a hard disk drive) and reconnect the cables. See page 4-8 for instructions.

Removing a Drive from an External Bay

To remove a drive from an external drive bay, follow these steps:

1.Remove the bracket and its drives. See page 4-2 for instructions.

2.Remove both the ribbon cable connector and the power cable connector from the drive to be removed from the external bay.

Installing and Removing Drives 4-21