2.Connect the 50-pin end of the cable to either the top or bottom SCSI connector of the scanner; then squeeze the wire clips together until they lock in place on both sides.

3.Connect the other end of the cable to the SCSI port of your computer or other SCSI device.

Note:

The SCSI port of the Macintosh is the larger port with the SCSI icon @ over it.

4.Plug in the power cables of your computer, scanner, and other external SCSI devices.

5.Turn on the scanner and any other external SCSI devices before you turn on your computer.

Turning on your computer and external SCSI devices

Always follow the power-on sequence described here when you turn on your computer and external SCSI devices.

If you have an internal hard disk, turn on the scanner and any other external SCSI devices you plan to use. Wait a few seconds; then turn on the computer.

Setting Up the Scanner 1-11