Epson 7900p Resetting the Lamp Timer, Press the, You see this screen:, 5.Select Yes, then press Enter, 1.Plug the projector in and turn it on

Resetting the Lamp Timer

After you replace the lamp, you need to reset the lamp timer using the projector’s menu.

1.Plug the projector in and turn it on.

2.Press the Menu button on the remote control (or on the projector’s control panel). You see the main menu.

3.Use the pointer button on the remote control (or the arrow buttons on the projector) to highlight About, then press Enter.

You see this screen:

Video		Lamp (High Brightness) :		0H
Audio		(Low Brightness) :		0H
Effect		Reset Lamp Timer	Execute
						Lamp usage
Setting		Source	: Computer
User's Logo		Input Signal	: Auto
Advanced1
		Frequency	: H ---.---kHz
Advanced2			: V ---.---Hz
About		SYNC Polarity	: H ------
Reset All			: V ------
		SYNC Mode	: ------
		Resolution	: ----x	----
		Refresh Rate	: ---.-- Hz
[ ]: Select [	]: Enter				[Menu]: Exit

4.Select Reset Lamp Timer, then press Enter. You see this prompt:

Reset Lamp Timer

Execute?

YES NO

note

The lamp usage timer shows 0H until you’ve used the lamp for at least 10 hours.

5.Select Yes, then press Enter.6.When you’re finished, press ESC or Menu to exit.

Maintaining the Projector 107