■To change the network addresses from the projector’s control panel, press the right and left arrow buttons to select the part of the address you want to enter, then use the up and down arrow buttons to increase or decrease the numeric value.

Increase or decrease

Select the

the value

part of the address to change

When you finish changing an address in the network menu, press the Enter button (on the remote control) or the Auto/Enter button (on the projector). This stores the value.

6.When done making all necessary changes, press ESC to exit the menu system.

Using EMP Monitor

EMP Monitor lets you manage all your projectors using a remote computer. This lets you easily turn the projectors on or off (together or individually), switch image sources, and check on their status.

Before using EMP Monitor, make sure you’ve installed the software as described on page 86. The computer you’re using to monitor the projector should already be connected to your network.

Managing the Projector from a Remote Computer 89