Status lights
Light | Status | Description |
|
|
|
| flashing red | Rapid cooling in progress. Although this is not an abnormal condition, |
|
| projection will stop automatically if the temperature rises too high again. |
| flashing orange | Make sure there is plenty of space around and under the projector for |
|
| ventilation, and that the air filters and vents are clear. |
|
|
|
| red | The projector is overheating, which turns the lamp off automatically. Wait |
|
| until the cooling fan stops, then unplug the power cord. Plug the power |
|
| cord back in and press the P Power button. Make sure the room |
|
| temperature is not above 95 °F (35 °C) and there is plenty of space |
|
| around and under the projector for ventilation. |
|
| The air filters may be clogged. Clean or replace them as described on |
|
| |
|
| If the projector continues to overheat after you clean the air filter, the |
|
| problem may be caused by damage to the cooling fan or temperature |
|
| sensor. Contact Epson for help. |
|
| Warning: Except as specifically explained in this User’s Guide, do not |
|
| attempt to service this product yourself. |
|
|
|
| red | It’s time to replace the lamp. See page 104 for instructions. If you |
| flashing orange | continue to use the lamp after the replacement warning, there is an |
| increased possibility that the lamp may break. | |
|
| |
|
|
|
| flashing red | The lamp may be burned out. First make sure the lamp cover is securely |
|
| installed. If that’s not the problem, remove the lamp and replace it as |
|
| described on page 104. If this does not resolve the problem, contact |
|
| Epson as described on page 121. |
|
|
|
| flashing red | Power is cut off because of an internal problem. Remove the power cord |
|
| and contact Epson for help, as described on page 121. |
|
|
|
| Red / Flashing | The lamp may be cracked or installed incorrectly. Check the lamp; if it is |
| red | cracked, you must replace it (as described on page 104) before you can |
|
| use the projector again. |
|
| Also make sure the air filters and intake vents are clean. (See page 103.) |
|
| Make sure the lamp and cover are installed correctly. (See page 106.) |
|
| If checking the lamp installation and replacing the lamp does not solve |
|
| the problem, contact Epson as described on page 121. |
|
|
|