locked. Request code xxxxx
Wrong password.

note

If you lose the remote control, you will not be able to enter the password, so keep the remote control in a safe place at all times.

6.Press Menu to close the Password Protect menu.

7.Turn off the projector and unplug the power cord to enable password protection.

When you turn the projector on again, you will need to enter a password. Follow the instructions in the next section.

note

When the period defined in the Time-elapsedsetting has passed, and the password is entered correctly, the elapsed time will be reset to 0 and the countdown will start again. Remember to disable or change this setting when you need to.

Starting the Projector with a Password

When the password function is enabled, you see this screen when you turn on the projector:

Password

Enter the password.

#Refer to the "User’s Guide" for the operation.

[0-9]:Enter

Press down the Num button on the remote control as you use the numeric keypad buttons to enter the password. Once you have entered the password correctly, the password screen closes, and projection begins.

If the password is not correct, you see the message

Please try again. If you enter an incorrect password three times in succession, you see the message The projector’s operation will be and the projector switches to standby

mode for approximately 5 minutes. Write down the request code. Then disconnect the projector’s power cord from the electrical outlet, reconnect it, and turn the projector back on.

When you see the Password Protect Release screen again, you can try to enter the correct password.

82Fine-tuning the Projector