Epson 7900p Shutting Down the Projector, Adjusting Color Corrections for a New Surface, Power, Press the, Wall Shot, Press the, Wall Shot, Wall Shot Readjustment

Adjusting Color Corrections for a New Surface

Adjust the correction values if you’re projecting on a new surface or in a new location.

1.Press the Wall Shot button on the remote control or projector while you’re projecting an image. Wait for the Wall Shot status screen.

2.Press the Wall Shot button until you see Wall Shot Readjustment on the status screen.

You see a sequence of colors flash for about five seconds as the projector adjusts the color correction values for the new projection surface.

Shutting Down the Projector

When you’ve finished using the projector, follow the recommended procedure to shut it down. This extends the life of the lamp and protects the projector from possible overheating.

1.Turn off and disconnect any equipment plugged into the projector.

2.To turn off the projector, press the red P Power button on the projector or remote control.

Power button

note

When the projector has not received any input signals for 30 minutes, it automatically turns off the projector lamp and enters “sleep mode.” This conserves electricity, cools the projector, and extends the life of the lamp. If you want to start projecting again, press the P Power button. If you are done using the projector, unplug the power cord. To turn off sleep mode, see page 76.

Turn off this product when not in use to prolong the life of the projector.

You see a confirmation message. (If you don’t want to turn it off, press any other button.)

Power OFF?

Yes : Press button

No : Press any other button

Projecting 49