note

Some LCD monitors may not be able to display the image correctly. If you have trouble displaying the image, connect a multiscan monitor. Also, make sure the computer’s refresh rate is set to 65 Hz or greater.

You cannot display video images or configuration and help menus on an external monitor.

3.Connect the flat end of the cable to any available USB port on your computer.

4.If necessary, configure your notebook to work with an external mouse.

If you don’t need to make any other connections, you can plug in your projector and turn it on. See page 30 for instructions.

Connecting an External Monitor

If you want to see your presentation close-up as well as on the projection screen, you can connect an external monitor to the projector. This lets you view images on your computer monitor while the projector is in standby mode (plugged in but not turned on) and check your presentation or switch between picture sources even if you’ve pressed the A/V Mute button on the remote control to turn off projection on the screen.

Simultaneous display is possible only when the computer is connected to the projector’s Computer1/Component Video1 port.

Make sure the projector and computer are off. Then connect the monitor’s cable to the projector’s Monitor Out port, as shown:

If you don’t need to make any other connections, you can plug in your projector and turn it on. See page 30 for instructions.

20Setting Up the Projector