note

When Direct Power is turned on, turn the projector off as you would normally. See page 41 for instructions.

When Direct Power is enabled, it’s a good idea to unplug the projector after turning it off. Otherwise the projector will turn on automatically when power is restored after a power failure.

■Projection

Front: Projector is in front of the screen.

Front/Ceiling: Projector is in front of the screen, mounted upside-down from the ceiling.

Rear: Projector is behind the screen.

Rear/Ceiling: Projector is behind the screen, mounted upside-down from the ceiling.

■Operation

Direct Power: When this feature is enabled, projection starts as soon as you plug in the power cord. You don’t have to press the P Power button.

Sleep Mode: When this feature is enabled, the projector lamp automatically turns off when the projector has not received any input signals for 30 minutes. This conserves electricity, cools the projector, and extends the life of the lamp. To resume projecting, press the P Power button.

■Standby Mode

Set to Network ON to monitor your projector over a network and perform other network functions when the projector is in standby mode.

■COM Port

Normally you don’t have to change this setting. Both USB and RS-232Clet you use the remote control as a wireless mouse. RS-232Cis also used for ASCII control codes and to control the projector from a computer with the EMP Link 21L software, which can be downloaded from www.support.epson.com. If you change the setting, turn the projector off and then on again to enable it.

■Language

Select the language to be used for projector menus and messages.

4.When you’re finished, press Esc or Menu.

60Fine-tuning the Projector