Install the SCSI Interface Board
You must install your SCSI board before installing the scanner driver and software applications.
If you have a Macintosh with a SCSI interface, or if you already have a SCSI board installed in your PC, skip this section.
For additional installation information, see your computer documentation.
1.Turn off the computer and any peripheral devices. Unplug any power cords; then disconnect all cables from the back panel of your computer.
2.Remove the cover from your computer (or open up your Macintosh G3).
Static electricity can damage electronic components. Ground yourself before you touch any of the computer’s internal components by touching an unpainted metal surface inside the computer case.
3. Remove the slot cover from an empty PCI expansion slot in your computer. (Refer to your computer documentation for information about your PCI slots.)
4. Insert the interface board into the slot; then secure it with the bracket screw.
5.Replace the computer cover and reconnect all cables.
6.Continue with the following section, “Unlock the Scanner.”
12