Epson EMP-30 manual Power Indicator, in Safety Instructions/World-Wide Warranty Terms

When Having Some Trouble

(Warning) Indicator

Power Indicator

Status	Cause	Remedy or Status	See Page
Red	Internal problem	Stop using the projector, disconnect the power cable from
		the electrical outlet, and contact your dealer or the nearest
(1-second		address provided at "International Warranty Conditions"
		in Safety Instructions/World-Wide Warranty Terms.
intervals)
Orange	High-speed	(This is not an abnormality, but if the temperature rises too
	cooling in	high again, projection will stop automatically.)	Setup Guide
	progress	• Set the projector up in a place which is well-ventilated,
		and so that the air filter and exhaust vents are clear.	p.44
		• Clean the air filter.

Power Indicator

		: lit	: flashing
Status	Cause	Remedy or Status	See Page
Orange	Standby status	(Not abnormal)	p.6
		The power cable should only be disconnected when the
		projector is in this condition.
		Press the [Power] button to start projection.
Orange	Cool-down in	(Not abnormal)	p.9
	progress	• Please wait.
		The cool-down period lasts for about 20 seconds.

•The [Power] button does not work during cool-down. Press the button again after cool-down ends.

Green	Projection in	(Not abnormal)	p.7
	progress
Green	Warm-up in	(Not abnormal)	p.7
	progress	Please wait.
		Warm-up time is approximately 40 seconds.
		After warm-up is complete, the flashing green indicator
		changes to steady green.

•If the projector is not operating properly even though the indicators are all showing normal, refer

to "When the Indicators Provide No Help" on the following page.

• If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/World-Wide Warranty Terms.

34