Epson EMP-740, EMP-732, EMP-737 manual Normal

User’s Guide

Problems Solving

77

		: lit	: flashing	: off
Status	Cause	Remedy or Status
	Lamp replacement notification	Replace the lamp with a new one. sp.101
Orange		If you continue to use the lamp after it has passed the replacement period, the possibility that the
		lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
		indicator status will vary depending on the projector status at the time.

Power indicator lights green or orange/flashes green or orange

Normal

: lit : flashing : off

Status Cause Remedy or Status

Orange	Standby condition	Projection starts again when the [Power] button is pressed.
		You can disconnect the power plug from the electrical outlet when the status light is in this
		condition.
Green	Warm-up in progress	Warm-up time is approximately 40 seconds. After warm-up is complete, the indicator stops
		flashing.

Green Projection in progress

Orenge	Cool-down in progress	Please wait.
		•The cool-downgperiod lasts about 20 seconds.

•The [Power] button will not operate if it is pressed while cool-down is in progress. When the cool-down period is finished and the confirmation buzzer has sounded and the indicator changes to light orange, repeat the operation.

TIP

•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" on the following page.

•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.