Epson EMP-TW20 Problem Solving, When the (warning) indicator is lit or flashing warning/problem, When the, (operation) indicator is lit or flashing, Reading the indicators

Problem Solving

Reading the indicators

The projector is provided with the following two indicators which notify you of the operating status of the projector.

The following tables show what the indicators mean and how to remedy the problems that they indicate.

*If both indicators are switched off, check that the power cable is connected correctly and that power is being supplied.

(operation) indicator

(warning) indicator

When the (warning) indicator is lit or flashing warning/problem

					: Lit	: Flashing
	Internal problem / Fan problem / Sensor problem
Red
			Disconnect the power cable from the electrical outlet. Then contact your dealer or
		CAUTION
(Lit/off for			the nearest address provided in the "International Warranty Conditions" section of
			the Safety Instructions/World-Wide Warranty Terms booklet.
1 sec)
	Lamp problem / Lamp on error
Red
	Check if the lamp is broken. s page 42
(Lit/off for				Replace the	If the problem is still not solved after the lamp is replaced, stop
0.5 sec)	If the lamp is			lamp and	using the projector and disconnect the power cable from the
					electrical outlet. Then contact your dealer or the nearest address
	not broken			then turn the
					provided in the "International Warranty Conditions" section of the
				power on.
					Safety Instructions/World Wide Warranty Terms booklet.

If the lamp is

broken

Contact your local dealer for further advice.

High internal temperature

Red (overheating)

The lamp will switch off automatically and projection will stop. Wait for approximately 5 minutes.

High-speed cooling in progress

You can continue using the projector, but if the temperature rises again, it will switch off automatically.

When the	(operation) indicator is lit or flashing
When the	(warning) indicator is off	: Lit	: Flashing

Standby

If you press , projection will start after a brief interval.

condition

Warm-up in	Warm-up time is approximately 30 seconds.
progress	Power off operations are ignored while warm-up is in progress.
Projection in	Normal operation is in progress.
progress
Cool-downgin	Cool-down time is approximately 20 seconds.
	After cool-down is complete, the projector goes to standby mode.
progress
	You cannot use the remote control or the projector's control panel during cool-down.

Troubleshooting

33