Problem Solving
If any of the following problems occur and the indicators do not offer a solution, refer to the pages given for each problem.
No images appear s See below
Projection does not start, the projection area is completely black, the projection area is completely blue, etc.
The message "Not Supported." is displayed 
page 35
The message "No Signal." is displayed s page 35
Images are fuzzy or out of focus s page 36
Interference or distortion appear in images s page 36
Problems such as interference, distortion or black & white checked patterns appear.
Image is truncated (large) or small s page 37
Only part of the image is displayed.
Image colours are not right s page 37
The whole image appears purplish or greenish, images are black & white, colours appear dull, etc.
(Computer monitors and LCD screens have different colour reproduction performance, so that the colours projected by the projector and the colours appearing on the monitor may not necessarily match, but this is not a sign of a problem.)
Images appear dark s page 38
Projection stops automatically s page 38
| Problems when projection starts |
|
|
| Other problems |
|
|
|
|
|
| ||
|
|
|
|
|
| |
| Power does not turn on s page 38 |
|
| No sound can be heard or the sound is faint | ||
|
|
|
|
| s page 38 | |
|
|
|
|
| The remote control does not work | |
|
|
|
|
| s page 39 | |
|
|
|
|
|
|
|
Problems relating to images
No images appear
Have you pressed the [Power] | Press | on the remote control or | on the projector's control |
| button? | panel. |
|
|
|
| ||
| Are all of the indicators | Disconnect the power cable and then reconnect it. s page 14 | ||
| switched off? | Check the circuit breaker to see if power is being supplied. | ||
|
|
| |
| Is A/V Mute mode active? | Press | on the remote control to cancel the A/V mute. | |
|
| ||
| Is a video signal being input? | Check that the power for the connected equipment is turned on. If the | ||
| "Message" menu command has been set to "ON", messages relating | ||
| to the image signals will be displayed. |
| |
| s "Setting" - "Display" - "Message" page 30 | ||
|
| ||
| Are the image signal format | If a composite videog or | ||
| settings correct? | If projection does not occur when the "Video Signal" menu | ||
| command is set to "Auto", select the signal format that matches the | ||
| signal source. |
| |
| s "Setting" - "Input Signal" - "Video Signal" page 30 | ||
|
|
|
|
34