Problem Solving
Have the colour intensity and tint been adjusted correctly?
Only when projecting images from a video source
Use the "Color Saturation" and "Tint" menu commands to adjust the colour and tint.
s "Image"- "Picture Quality" - "Color Saturation", "Tint" page 26
Images appear dark
Has the image brightness been | Use the "Brightness" menu commands to make the adjustments. |
adjusted correctly? | s "Image" - "Picture Quality" - "Brightness" page 26 |
|
|
Has the image contrastg | Use the "Contrast" menu command to adjust the contrast. |
been adjusted correctly? | s "Image" - "Picture Quality" - "Contrast" page 26 |
|
|
Is the lamp due for | When the lamp is nearly due for replacement, the images will |
replacement? | become darker and the colour quality will become poorer. When this |
| happens, the lamp should be replaced with a new one. s page 42 |
|
|
Projection stops automatically
Is sleep mode active? | When "Sleep Mode" has been set to ON, the lamp turns off | ||
| automatically if no signal is input for about 30 minutes, and the | ||
| projector switches to standby mode. Press the | button on the | |
| remote control or the | button on the projector's control panel to | |
| turn the projector's power back on. To cancel the sleep mode setting, | ||
| change "Sleep Mode" menu command to "OFF". |
| |
| s "Setting" - "Operation" - "Sleep Mode" page 29 | ||
|
|
|
|
Problems when projection starts
Power does not turn on
Have you pressed the [Power] | Press | on the remote control or | on the projector's control | |
button? | panel. |
|
|
|
|
|
| ||
Is "Child Lock" set to "ON"? | If the "Child Lock" menu command is set to "ON", press | on the | ||
| projector's control panel for about 3 seconds or press | on the | ||
| remoto control to turn the power on. |
|
| |
| s "Setting" - "Operation" - "Child Lock" page 29 |
| ||
|
| |||
Are all of the indicators | Disconnect the power cable and then reconnect it. s page 14 | |||
switched off? | Check the circuit breaker to see if power is being supplied. |
| ||
|
| |||
Do the indicators turn off and | Turn the power off, disconnect the power cable and then reconnect it. If this | |||
on when the power cable is | does not solve the problem, there may be a problem with the power cable. | |||
touched? | Then contact your dealer or the nearest address provided at "International | |||
| Warranty Conditions" in Safety | |||
| booklet. |
|
|
|
|
|
|
|
|
Other problems
No sound can be heard or the sound is faint
| Is the audio source connected | Check that the cable is connected to the [Audio] input port. | |
| correctly? |
|
|
|
|
| |
| Has the volume been adjusted | Adjust the volume so that sound can be heard. s page 17 | |
| to the minimum setting? |
|
|
|
|
|
|
38 | Is A/ V Mute mode active? | Press | on the remote control to cancel the A/V mute. |
|
|
| |
|
|
| |