Your computer may have a hard disk drive already installed in the vertical drive bay. If not, you can install one hard disk drive in this bay.

It is best to install your computer’s first hard disk drive in the vertical drive bay. If you add a second hard disk drive or diskette drive, use the lower horizontal drive bay.

How to Use This Chapter

To install or remove a drive, first remove the computer’s cover as described on page 2-4. Then see the table below for a guide to the instructions you should follow next in this chapter.

To . . .

Install a hard disk drive

Install a diskette drive or other device in a horizontal drive bay

Remove a diskette drive or other device from a horizontal drive bay

Remove a hard disk drive from the vertical bay

see...

“Setting the Hard Disk Drive Jumpers” on page 3-4

Page 3-l 7

Page 3-29

Page 3-15

After you install or remove your drive(s), replace the computer’s cover as described on page 2-24. Then see “Post-installation Procedures” on page 3-36 for additional steps you may need to perform.

Installing and Removing Drives 3-3