The Cut Sheet Feeder

Testing the Printer in the Cut Sheet Feeder Mode

When you perform the cut sheet feeder self test, the printer counts the number of lines on the page. As shown on the following page, the number of lines counted is printed out at the bottom of the first test page. This number is the default page-length setting. This setting, however, can be overridden by software commands.

Running the self test is the same as when the cut sheet feeder mode is off. The steps below are for a self test in draft mode.

Note: Run the self test using paper that is 8¼ inches (210 mm) wide on the standard width printer and 14 inches (360 mm) wide on the wide carriage printer.

Using the Printer Options

5-9