Epson PowerLite 7900p Replacing the Lamp and Air Filters, The message, as soon as possible, 1.Turn off the projector, 104Maintaining the Projector

note

When you get a replacement lamp for your projector, new air filters are included. You should replace the filters when you replace the lamp.

Turn the projector off when not in use. Continuous

24-hour-a-day use may reduce the overall life of this product.You can check how long the lamp has been in use (see page 107).

warning

Let the lamp cool fully before replacing it.

In the unlikely event that the lamp has broken, small glass fragments may be present and should be removed carefully to avoid injury.

4.If the dirt is difficult to remove or a filter is broken, replace the filters as in the following section. Contact your dealer or call Epson at (800) 873-7766 in the United States to obtain new ones. In Canada, please call (800) 463-7766 for dealer referral.

Replacing the Lamp and Air Filters

The projection lamp typically lasts from 2000 to 3000 hours, depending on the Brightness Control setting used (see page 68). Selecting the low brightness setting maximizes the lamp’s life.

It is time to replace the lamp when:■The projected image gets darker or starts to deteriorate.

■The message LAMP REPLACE appears on the screen when the lamp comes on and the lamp warning light flashes orange. To maintain projector brightness and image quality, replace the lamp

as soon as possible.■The lamp warning light flashes red (the lamp is burnt out).

Contact your dealer or call Epson at (800) 873-7766 in the United States for a replacement lamp. Request part number V13H010L22. In Canada, please call (800) 463-7766 for dealer referral.

Follow these steps to replace the lamp and air filters:1.Turn off the projector.2.When the power light stops flashing, unplug the power cord.

3.Let the projector cool for at least an hour (if it has been on). The lamp is extremely hot immediately after use.

104Maintaining the Projector