40 Maintaining the Projector
7. To install a new filter, first insert the tabs, then press down until it
clicks in place.
Replacing the Lamp
The projection lamp typically lasts for about 3000 hours of use. It is
time to replace the lamp when:
■The projection image gets darker or starts to deteriorate.
■The lamp light is red or flashing orange.
■The message LAMP REPLACE appears on the screen when the
lamp comes on (after about 2900 hours of use). To maintain
projector brightness and image quality, replace the lamp as soon
as possible.
Contact your dealer or call EPSON at (800) 873-7766 in the United
States for a replacement lamp. Request part number V13H010L17. In
Canada, call (800) 463-7766 for dealer referral.
Be sure to read the “Important Safety Instructions” on page 63 befor e
replacing the lamp; then follow these steps:
1. Turn off the projector and wait for it to cool down (until the light
stops flashing).
2. Turn off the power switch on the back of the projector and
unplug the power cord.
3. Allow the projector to cool for at least half an hour (if it has been
on).
warning
Be extremely careful when
removing the lamp module.
In the unlikely event that the
bulb has ruptured, small glas
s
fragments may be present an
d
should be removed with
caution.
If your projector is mounted
on the ceiling, you should
take it down before accessing
the lamp compartment. This
will make it easier for you to
replace the lamp and
minimize the chance of any
small glass fragments
dropping from the projector .
warning
Let the lamp cool before
replacing it. If the lamp
breaks, handle the shards
carefully to avoid injury.