Note: Paper

configurations are needed only for non-Epson media.

Note: You can also create paper configurations using the Epson LFP Remote Panel installed from the printer software CD.

Handling Paper and Other Media 83

Optimizing the Settings for Your Paper

When you choose a media type in your Epson printer software, the driver automatically determines the best settings for your paper. However, you may want to fine-tune how the printer handles various media—especially if you use non-Epson paper or a paper not supported by the driver. Use the paper configuration settings described below.

You can create a special configuration, or group of settings, for each paper type (up to ten types) and select the desired configuration whenever you print on a particular stock.

Creating Paper Configurations

To create a configuration for a specific paper type, make sure the paper you want to configure is loaded in the printer. Then follow these steps:

1.Press r Menu, then press u or d to select PAPER SETUP.

2.Press r, then press d to select CUSTOM PAPER.

3.Press r, then press d or u to select a paper configuration number (1 to 10). Press r to save the number setting.

4.Press d or u to select PAPER TYPE, then press r. Press d or u to select a media type, then press r. Press OK to save it.

5.Press l twice to go back to the previous menu.

6.Press d or u to select PLATEN GAP, then press r. Press the d button to select NARROW, STANDARD, WIDE, or WIDER. The

STANDARD setting is recommended for most paper types. Press OK to save the setting, then press l to go back to the previous menu.

7.Press d or u to select THICKNESS PATTERN, then press r. Press OK to print the paper thickness pattern. A pattern similar to the following is printed:

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

Smallest gap