Epson V11H561020 manual Connecting to a Component-to-VGA Video Source

Parent topic: Connecting to Video Sources

Related tasks

Connecting to External Speakers

Connecting to a Component-to-VGA Video Source

If your video source has component video ports, you can connect it to the projector using an optional component-to-VGA video cable. Depending on your component ports, you may need to use an adapter cable along with a component video cable.

1.Connect the component connectors to your video source's color-coded component video output ports, usually labeled Y, Pb, Pr or Y, Cb, Cr. If you are using an adapter, connect these connectors to your component video cable.

2.Connect the VGA connector to a PC port on the projector.

3. Tighten the screws on the VGA connector.

If your image colors appear incorrect, you may need to change the PC Signal setting in the projector's Extended menu to Component.

Note: If you connected a game console, it may take a few seconds for your image to appear when you switch to the game console's input source. To reduce the potential lag in response time to game commands, set your game console's output format to a progressive signal of 480p or 720p. See your game console documentation for instructions.

You can also select the Fast setting using the Fast/Fine button on the remote control to reduce lag time.

Parent topic: Connecting to Video Sources

Related references

Projector Setup Settings - Extended Menu

28