162
162 |Maintaining and Transporting the Printer
•To change the units of measurement, press d to highlight LENGTH
UNITS, then press r. Press d to switch from METRIC to
FEET/INCH, then press OK to select it. Press l when done.
•To change the temperature units of measurement, press d to
highlight TEMPERATURE UNITS, then press r. Press d to switch
from C (Celsius or centigrade) to F (Fahrenheit), then press OK to
select it. Press l when done.
•To change the maximum roll paper tension, press d to highlight
ROLL PAPER TENSION, then press r. Press d to decrease the
maximum value, or u to increase it (from 1 to 5). Press OK to select
the setting you want.
•To run a super strong cleaning cycle, press d to highlight
SS CLEANING, then press r to display EXECUTE. Press OK to
start the cleaning cycle.
•To return all control panel settings to their default values, press d to
highlight DEFAULT PANEL, then press r to display EXECUTE.
Press OK to restore the default settings.
4. To exit maintenance mode, turn off the printer by pressing the Ppower
button. Press the Ppower button again to turn on the printer in the
normal operating mode.
Replacing the Paper Cutter
If you notice that your paper isn’t being cut cleanly, the cutter may need to
be replaced.
You can obtain a new cutter from Epson (part number C12C815331). See
page 12 for ordering details.

Removing the Old Cutter

Make sure the printer is turned on, then follow these steps to remove the
blade:
1. Press r Menu.
2. Press d until MAINTENANCE is highlighted, then press r.