Important Information
Note:
This information is only applicable for units sold for the
U.S. market.
8.3.2.1UL Required Information
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:
1Do not use this product near water, for example, near a bathtub, washbowl, and kitchen sink or laundry tub, in a wet basement or near a swimming pool.
2Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
3Do not use the telephone to report a gas leak in the vicinity of the leak.
CAUTION! To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
CAUTION! Always disconnect all telephone lines from the wall outlet before servicing or disassembling this equipment. For use only with UL Listed Personal Computer.
8.3.2.2 FCC Required Information
8.3.2.2.1 FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules (Code of Federal Regulations Title 47, Telecommunications (CFR 47)). These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with these instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will occur in a particular installation. If this equipment does cause harmful interference to radio or television, which can be determined by turning the equipment off and on, the user is encouraged to eliminate the interference by one or more of the following measures:
∙Reorient or relocate the receiving antenna of the affected equipment.
∙Increase the separation between the ADSL Modem HM121d and the affected equipment.
∙Connect the ADSL Modem HM121d power supply to an outlet on a circuit different from that to which the affected equipment is connected.
40 (47) | EN/LZT 108 6429 R1 |
May 2003
