Remote Control Unit

How to insert the batteries

Remove the cover of the remote control unit with a screwdriver. After checking the polarity (+/_) of two AA batteries, insert the batteries, replace the cover and replace the screws.

Battery Replacement

If the distance you can operate your remote decreases, the batteries are exhausted. In this case replace the batteries with new ones.

Precautions concerning batteries

<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.

<Use batteries of the same type. Never use different types of batteries together.

<Rechargeable or non-rechargeable batteries can be used but not mixed together. Refer to the precautions on their labels.

<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.

<Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire.

Notes on use

<Point the remote control unit at the main unit’s remote sensor within seven meters (23 feet) of the main unit. There should not be any obstacles between the main unit and the remote control unit.

<Do not allow direct sun or other light to shine on the remote sensor part of the main unit. This may cause the remote control unit to work incorrectly.

<Note that other units with remote controls may operate incorrectly because of infrared light “overspill” when you operate this remote control unit.

Restoring factory settings

If you have made a lot of changes to the setup, and want to restart from a known set of options, restore the unit to the factory settings as follows:

1.Unplug the power cord from the outlet.

2.While holding down the SETUP button, plug the power cord into the outlet.

All memories are erased, and the unit returns to the factory settings.

9