Extron electronic 6400s manual IptX3@, X3#, IpzX3$, X3%, IpiX3, IpsX3, IpgX3, IpuX3, X3,X4,X3 EX4

Programmer’s Guide, cont’d

Command/response table for IP-Specific SIS commands

Command	ASCII command	Response	Additional
	(host to switcher)	(switcher to host)	description
IP setup commands
Set matrix name	EX3)CN}	Ipn•X3)]
Read matrix name	ECN}	X3)]
Reset matrix name to	E•CN}	Ipn•X3)]	“Fiber-Matrix-64-”plus the last
factory default			3 pairs of the MAC address.
Set time and date	EX3@CT}	IptX3@]
Read time and date	ECT}	X3#]
Set GMT offset	EX3$CZ}	IpzX3$]	In the command, the divider
			between hours and minutes
			can be either a colon or a
			period. In the response, the
			divider is a colon.

Example:

Set Daylight Saving Time Read Daylight Saving Time Set IP address

Read IP address

Read hardware address Read # of open connections Set subnet mask

Read subnet mask

Set gateway IP address Read gateway IP address Set administrator password

Read administrator password

Reset (clear) administrator password

Set user password Read user password Reset (clear) user password

Set mail server, domain name

Read mail server, domain name

Set e-mail recipient

E8.0CZ}					Ipz+08:00]
EX3%CX}					X3%]
ECX}					X3%]
EX3^CI}					IpiX3^]
ECI}					X3^]
ECH}					X3&]
ECC}					X3*]
EX3^CS}					IpsX3^]
ECS}					X3^]
EX3^CG}					IpgX3^]
ECG}					X3^]
EX3(CA}					Ipa•X3(]
ECA}					X3(]
E•CA}					Ipa•]
EX3(CU}					Ipu•X3(]
ECU}					X3(]
E•CU}					Ipu•]
EX3^,X4),X3(CM}					IpmX3^,X4),X3(]
ECM}					X3^,X4),X3(]
EX4!	,	X4@	CR	}	X4!X4@ ]	This command sets the
					Ipr , ,

recipient. To receive e-mail notifications, you must then set the events that the switcher reports, using one or more separate Set e-mail events (EM) commands (see next page).

Example:	E72,Jsmith@folklore.netCR}
	EX4!CR}	Ipr72,Jsmith@folklore.net,]
Read e-mail recipient		X4@,]

4-18 Fiber Matrix 6400 Switcher • Programmer’s Guide