Extron electronic 68-1034-02 Rev. A user manual 2-20DVI 201 Tx/Rx Installation and Operation

Installation and Operation, cont’d

DVI 201 Rx Front Panel

RS-232

PASS THRU

Tx Rx

DVI 200 Rx Series

12

DVI 201 A D Rx Front Panel

OUTPUT

DVI

AUDIO L+R

13

9

RS-232

PASS THRU

12	Rx
	Tx

	Figure 2-17 — DVI 201 Rx front panel connectors
H	Receiver input connector — Connect one end of the two
	separate TP cables from the transmitter output connectors (item
	Fon page 2-17) to these RJ-45 female connectors.
	C Do not connect these devices to a computer data or
	telecommunications network.
	N In order to fit in the junction box, the TP cables and
	RJ-45 connectors should not have a boot installed.
	N Connect transmitter output 1 to receiver input 1.
	Connect transmitter output 2 to receiver input 2.

NIf necessary, test for proper cable connection (output 1 to input 1, output 2 to input 2) as follows:

1. Plug both TP cables into the powered unit.

2. Momentarily connect either of the cables on the opposite end into the unpowered unit‘s “2” connector.

If the unpowered unit’s Power LED is lit, the connection is correct.

If the unpowered unit’s Power LED is not lit, unplug the connector on the unpowered end and connect the other cable to the “2” connector.

See "TP cable termination," on page 2-23, to properly wire the RJ-45 connectors.

I	DVI Output connector — Connect a DVI monitor or projector
	for display of the transmitted direct digital image. See "DVI
	connector pin assignments," on page 2-22, for pin assignments.
J	Audio Input connector (DVI 201 A D Rx [Decora] only) —
	Connect one end of a 5-wire audio cable to this 3.5 mm, 5-pole
	direct insertion connector.

Connect the free end of the same cable to any compatibly wired audio source unit, such as a switcher's output or a DVI 201 A D Tx (Decora) transmitter.

Figure 2-18 shows how to wire the captive screw audio connector. Insert the wires into the appropriate openings in the direct insertion connector. Tighten the screws on the side to fasten the wires.

Unbalanced Input Balanced Input

	R	Sleeve		R	Ring
AUDIO	OUTPUT	Tip	AUDIO	OUTPUT	Tip
	L			L	Ring	Do not tin the wires!
					Sleeve (s)
		Sleeve			Tip
		Tip

Figure 2-18 — Captive screw connector wiring for receiver audio output

K	DC power input connector — Plug the included external
	12 VDC power supply into either this connector or the power
	input connector on the transmitter (item Eon page 2-17). See
	"Power supply wiring," on page 2-25, to wire the connector.

2-20 DVI 201 Tx/Rx • Installation and Operation DVI 201 Tx/Rx • Installation and Operation 2-21