Extron electronic manual Only DVS 406 D and DVS 406 AD models have an SDI connector

Equipment following the SCART interconnection standard may be connected using the RGBcS input cabling configuration.

4S-video/Composite video inputs — Connect an S-video or composite video signal to the appropriate female BNC connector(s), as shown here.

Y	Y
/VID	/VID
C	C
Composite video	S-video
input	input

5SDI (serial digital interface) input connector — Connect an SDI signal to this female BNC connector.

Only DVS 406 D and DVS 406 AD models have an SDI connector.

6Output 15-pin HD connector — Connect a display device to this female VGA-style connector for RGB output.

Both outputs 6 and 7 are buffered and can be connected simultaneously to two different displays. The sync format will be the same for both outputs.

7Output BNC connectors — Connect coaxial cables from a display device to these BNCs for one RGBHV, RGBS, or RGsB/RsGsBs video output as follows:

R

G

B

H/HV

V

R

G

B

H/HV

V

R

G

B

H/HV

V

RGBHV

RGsB (Sync on Green)

RGBS

RsGsBs (output only if input is RsGsBs)

Both outputs are buffered and can be connected simultaneously to two different displays. For RGB inputs, the output signal’s sync format is based on the format of the incoming RGB signal. For all other types of inputs, the user selects the output sync format. The sync format will be the same for both outputs.

8RS-232 port — This connector provides for two-way RS-232 communication. See chapter three, “Serial Communication”, for information on how to install and use the control software and SIS commands.

The default protocol is 9600 baud, 1 stop bit, no parity, and no flow control.

The rear panel RS-232 9-pin D connector has the following pin assignments:

Pin RS-232 function Description

1	–	No connection
2	Tx	Transmit data
3	Rx	Receive data
4	–	No connection
5	Gnd	Signal ground
6	–	No connection
7	–	No connection
8	–	No connection
9	hardwired IR	IR input

5 1

96

DB9 Pin Locations

Female

DVS 406 • Installation and Operation 2-5