Menus, Configuration, and Adjustments
Scaler configuration and adjustments can be performed by using the front panel controls and the menus that are displayed on the IN1502’s LCD screen. These menus are used primarily when the scaler is first set up.
Moving through menus by using front panel controls
Menu button — Press the Menu button to activate menus and to scroll to the four main menus.
Next button — Press the Next button to move between the submenus of a selected main menu. Pressing the Next button during input configuration causes the current input’s number and format type to be displayed on the LCD.
Adjust (
, 
) knobs — In configuration mode, rotate the horizontal Adjust (
) knob and vertical Adjust (
) knob to scroll through submenu options and to make adjustment selections. Refer to the flowcharts in this chapter and to specific sections for explanations on knob adjustments.
The Adjust knobs have no mechanical limits to their rotation.
Menu overview
After the initial power up menus display, the default menus appear on the LCD screen when no adjustments are actively being made. They cycle between the menu screen showing the active input’s number and video format, and the menu screen showing the output rate, as shown in the example flowchart below.
Power
on
INPUT 1
CMPOSITE
|
|
|
|
|
| EXTRON |
|
2 sec. |
| IN1502 | 2 sec. |
|
|
|
|
|
|
|
|
|
|
|
|
INPUT 1 |
| 2 sec. | |
CMPOSITE | DEFAULT CYCLE | ||
|
| 2 sec. |
|
|
|
| |
|
|
| |
2 sec.
1360 x
765 @60
NO
2 sec. | SIGNAL | 2 sec. |
NOTE The No Signal default menu only occurs if there is no signal present at the currently selected input connector.
Default menus
The No Signal default menu only occurs if there is no signal present at the currently selected input connector.
From any menu or submenu, after ten seconds of inactivity the IN1502 saves all adjustment settings and times out to the default menus.
IN1502 • Installation and Operation |
