Extron electronic ISM 182 manual Quick Start Integration Scaling Matrix Switcher, cont’d, QS-2

Quick Start — Integration Scaling Matrix Switcher, cont’d

Step 8

If desired, connect a network WAN or LAN hub, a control system, or computer to the Ethernet RJ-45 port. For connection to a network hub, router, or switch, wire the network interface cable as a straight-through cable. For connection to a computer or control system, wire the network interface cable as a crossover cable.

Configure the outputs

1. Press Menu > Menu > Next.

2. Rotate the Adjust knob to select the output rate for the output indicated on the LCD (for example, output 1).

3. Rotate the Adjust knob to select the output frequency.

Clip Down

1 2 3 4 5 6 7 8 RJ-45

connector

Straight-through cable

	Side 1		Side 2
Pin	Wire color	Pin	Wire color
1	White-orange	1	White-orange
2	Orange	2	Orange
3	White-green	3	White-green
4	Blue	4	Blue
5	White-blue	5	White-blue
6	Green	6	Green
7	White-brown	7	White-brown
8	Brown	8	Brown

4. Configure the unselected output (for example, output 2) by pressing the appropriate output button and rotating the knobs as necessary.

5. Press Next.

6. Rotate the Adjust knob to select the output video sync format (RGBHV or RGBS).

7. Rotate the Adjust knob to select the sync polarity.

1 2 3 4 5 6 7 8 Crossover cable

8. Configure the unselected output (for

Twisted

Pairs

1&2 3&6 4&5 7&8

	Side 1		Side 2
Pin	Wire color	Pin	Wire color
1	White-orange	1	White-green
2	Orange	2	Green
3	White-green	3	White-orange
4	Blue	4	Blue
5	White-blue	5	White-blue
6	Green	6	Orange
7	White-brown	7	White-brown
8	Brown	8	Brown

example, output 1) by pressing the appropriate output button and rotating the knobs as necessary.

9. Press Menu > Menu > Menu > Next to return to the default display cycle.

Create a tie

1. Select video and/or audio to switch by pressing the Video/Audio button as necessary to light the green Video LED and/

Step 9

Plug the Integration Seamless Matrix switcher and input and output devices into a grounded AC source, and turn on the input and output devices.

Setup and Operation

Configure the inputs

1. Press Menu > Next.

2. Press an input button (to select the input to configure).

3. Rotate the Adjust knob to select the input video type.

4. Rotate the Adjust knob to select the input audio gain or attenuation level.

5. Select other inputs to configure as necessary by pressing the appropriate input button.

6. Press Menu > Menu > Menu > Menu > Next to return to the default display cycle.

or the red Audio LED as desired.

2. As necessary, press the Output 1 or Output 2 button to select the desired output. (Only one output can be selected at a time.) The Output LED indicates the selected output.

3. Press an input button to select a video and/ or audio input for the selected output. The output 1 selection is indicated by the solid green (video) and/or red (audio) Input LED(s).

4. Press the unselected Output button to tie an input to that output or to view that tie. Both input selections can be viewed in the LCD display cycle.

Auto Image™

Initiate the auto imaging function for a specific input by pressing and holding the appropriate input button until the LCD displays the message Auto Image Input #n, releasing the input button, and then pressing and releasing the input button again.

QS-2