Optimizing the Video, IP information | Extron electronic ISM 182

Operation, cont’d

IP information

To set up the ISM for operation via its Ethernet port, you need to know and be able to change the IP address. One way to do this is via the IP address and hardware address screen.

To access the IP address and hardware address screen, press and hold the Color/Tint and Detail buttons while you apply power to the ISM (figure 3-15). When the ISM is finished intializing, it displays both addresses.

Press and hold both buttons

simultaneously while applying power

COLOR/

TINT

DETAIL

IP Address

Power

>192.168.254.254 Hardware Address 00-80-00-00-04-04

Select the IP address subfield	Change the subfield value
with the Adjust knob.	with the Adjust knob.

IP Address 192.168.254>253

Hardware Address 00-80-00-00-04-04

10 sec.	NOTE The hardware address is
	hardcoded and cannot
Default	be changed.
Cycle

Figure 3-15 — IP information flowchart

If you need to change the IP address, use the Adjust knob to select the desired subfield. Rotate the Adjust knob to change the value. Repeat the adjustment for other subfields as required.

Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots (periods). Each field can be numbered from 000 through 255. Leading zeroes, up to 3 digits total per field, are optional. Values of 256 and above are invalid.

If the local system administrators have not changed the value, the factory- specified default, 192.168.254.254, is the correct value for this field.

The hardware address is hardcoded and cannot be changed.