Installation, cont’d

Rack mounting instructions

On the standard rack shelf, the MTP mounts in one of eight locations to the rear of the rack or in one of eight locations to the front of the rack.

1.

Remove the feet from the bottom of the MTP, if installed.

2.

Mount the MTP using two 4-40 x 3/16" screws in opposite

 

(diagonal) corners to secure the MTP to the shelf.

3.

Install blank panel(s) or other unit(s) to the rack shelf.

Furniture or projector mounting (all except AAP models)

Use the optional mounting kit (furniture, part #70-212-01,or projector, part #70-217-01) to mount the MTP as follows:

1.

Remove the feet from the bottom of the MTP, if installed.

2.

Attach the mounting brackets to the MTP with the

 

machine screws provided (figure 2-10).

 

Mounting

 

Bolt

 

Projector

 

Mounting

 

Bracket

 

Ceiling

 

Projector

Under Desk Mounting

Projector Mounting

Figure 2-10 — Desk and projector mounting the MTPs 3. For furniture mounting

a.

Hold the MTP with the attached brackets against the

 

underside of the mounting surface. Mark the bracket

 

screw hole locations on the mounting surface.

b.

Drill 3/32" (2 mm) diameter pilot holes, 1/4"

 

(6.3 mm) deep in the mounting surface at the marked

 

screw locations.

c.

Insert #8 wood screws into the four pilot holes.

 

Tighten each screw into the mounting surface until

 

just less than 1/4" of the screw head protrudes.

d.

Align the mounting screws with the slots in the

 

brackets and place the MTP against the surface, with

 

the screws through the bracket slots.

e.

Slide the MTP slightly forward or back, then tighten

 

all four screws to secure the MTP in place.

4. For projector mounting, secure the MTP to a projector mount by inserting the mounting bolt through the bracket’s slotted hole.

Frame mounting (AAP models)

The AAP-mountable transmitters (MTP T SVA AAP and

MTP T AV AAP) can be mounted to any Extron AAP mounting frame that accepts a double space (double height) AAP module. See “AAP accessories” in the appendix for a partial list of AAP devices.

The rear panel MTP connections will be inaccessible after installation. Make all connections (see “Transmitter/ receiver throughput connections”, page 2-15)and test the twisted pair system (apply a video source and observe that transmitted video is displayed satisfactorily) before installing the panel-mounted transmitter.

Install an MTP transmitter in an AAP frame as follows (figure 2-11):

AAP 102

 

AAP

102

 

 

MTP T

 

 

AV

AAP

 

MTP T AV AAP

Figure 2-11 — AAP mounting an MTP transmitter

1. If necessary, remove the AAP frame from the device in which it is installed.

2-10 VersaTools® MTP Series • Installation

VersaTools® MTP Series • Installation 2-11

Page 12
Image 12
Extron electronic MTP manual Furniture or projector mounting all except AAP models, Frame mounting AAP models