Extron electronic MTP manual Installation, cont’d, 3 - Video board jumper locations

Installation, cont’d

5.	Locate the jumper blocks (figure 2-3) on the video board.
	Shift the jumper to the alternate location.
Mono (default jumper position)
Compatible with new model transmitter/receivers.
Cannot remotely power transmitter/receiver
Transmitter Front Panel		Receiver Front Panel

TransmitterReceiver Rear Panel

Rear Panel

Stereo

Compatible with old model transmitter/receivers.

Can remotely power transmitter/receiver.

Figure 2-3 — Video board jumper locations

6. Reinstall the audio board and secure it in place with the screws removed in step 4.

7. If the receiver is an audio unit, locate the jumper block on the audio board (figure 2-4). Shift the jumper to the alternate location.

Receiver Front Panel

Mono (default jumper position)

Compatible with new model transmitters.

Mono audio.

Cannot remotely power transmitter

Stereo

Compatible with old model transmitters.

Stereo audio.

Can remotely power transmitter.

Receiver Rear Panel

Figure 2-4 — Receiver audio board jumper locations

The jumper locations and functions are the same whether the receiver is equipped with captive screw or RCA audio connectors.

8. Replace the cover and the four screws removed in step 1.

2-4 VersaTools® MTP Series • Installation VersaTools® MTP Series • Installation 2-5