Extron electronic SW12 VGA ARS, SW8 VGA Ars manual Front Panel, Hold Press Description and Result

Front Panel

The SW8/12 VGA Ars switcher front panel controls are described below.

12

AUTO SWITCH 1 2 3 4 5 6 7 8

ACTIVE

MODE NORMAL AUTO

SW8 VGA Ars

3 4 5

Figure 2-17 — SW8 VGA Ars front panel

1							2
AUTO SWITCH	1	2	3	4	5	6	7	8	9	10	11	12
ACTIVE
	MODE	NORMAL	AUTO

SW 12 VGA Ars

3 4 5

Figure 2-18 — SW12 VGA Ars front panel

A B

Auto switch active LED — Lights when the auto switch mode is enabled.

Input buttons and LEDs— Depending on the model there are eight or twelve input buttons and corresponding LEDs. To select an input, press the desired input button. The adjacent LED lights.

	C	Mode (Input 1) button — The Mode button functions in conjunction with
		other buttons as shown in the table below. Mode is a secondary function of
		the Input 1 button.
Hold	Press		Description and Result
Mode	Normal		Enable Normal mode — Front panel input buttons operate normally.
			Auto Switch Active LED is off.
Mode	Auto		Enable Auto switch mode — Front panel input buttons are locked out.
			Switcher outputs highest number input that has a sync signal present. If
			no sync signal is present, input #1 is selected by default.
			Auto Switch Active LED is on.
Mode	Input button		Enable/disable Executive mode — All LEDs flash 3 times. All front panel
	#4 for 3 sec.		input buttons are locked out. Attempts to select an input button causes
			all LEDs to flash.
			Input selections via RS-232 and VSW IAAP still function.
			Disable Executive mode — All LEDs flash three times, and the front
			panel input buttons return to operation.
Mode - while applying			Perform factory reset — Reset unit to its factory settings.
power
	D	Normal (Input 2) button — Hold Mode and press Normal to have the front
		panel input buttons operate in manual mode - press an input button to select

an input signal.

SW8/12 VGA Ars • Installation and Operation 2-13