Extron electronic user manual Quick Start Guide SW4 3G HD-SDI, Installation

Control

System

Quick Start Guide — SW4 3G HD-SDI

Installation

Step 1

Turn off all of the equipment and disconnect it from the power source.

Step 2

(Optional) Mount the switcher on one of the rack options.

Step 3

6" Deep Rack Shelf

1/2 Rack Width Front

False Faceplate

Front false faceplate uses 2 screws.

(2) 4-40 x 3/16" Screws

Use 2 mounting holes on opposite corners.

Connect the video input cable(s). Connect up to four video inputs to the switcher’s BNC input connectors 1 through 4. See “Rear Panel Connections”

in chapter 2, “Installation and Operation.”

Step 4

Attach the video output cable(s). Connect one or two video output devices to the

Extron

SW4 3G HD-SDI

Multi-Rate SDI

Switcher

HD-SDI Monitor

switcher’s BNC output connectors (SDI, HD-SDI, or

3G-SDI).

	HD-SDI
HD-SDI VTR	Projector
	HD-SDI Cameras

NOutputs 1 and 2 output identical signals.

Step 5

If the switcher is to be connected to a computer or host controller for remote control, wire the provided 3-pole captive screw connector to an RS-232 cable. Connect the cable to the RS-232 port on the switcher’s rear panel and to the host’s RS-232 port (see the serial port pinout on the next page).

The RS-232 port has the following protocol:

•	9600 baud	•	No parity
•	1 stop bit	•	8 data bits

QS-1 SW4 3G HD-SDI • Quick Start Guide