Extron electronic TP T 15HD A, TP T BNC DA4 TP T 468 Template, TP T 468 4-gang Cut-outTemplate

Specifications, Accessories, and Part Numbers, cont’d

Blank Plate (no connector)	Blank Plate (no connector)
Single Space
2 - BNC	Double Space
	5 - BNC (Double)
3 - BNC
2 - RCA to Solder Cups
	2 - RJ-11
3 - RCA to Solder Cups
2 - S-video	1 - D-9 Pass Through Connector
2 - F Connectors	1 - HD-15 Pass Through Connector
2 - 1/4" Stereo Phono
	1 - 3-pin XLR Connector
2 - 3.5mm Stereo Mini

Figure A-1 — Architectural adapter plates

TP T 468 Template

The following template is actual size. It also includes the recommended 0.1" (0.25 cm) clearance on all sides of the electrical wall box to allow room for raised area surrounding the knockout.

The dashed line on the template indicates the cut-out area for installing a wall box. If you plan to install the TP T 468 without a wall box, use the smaller cut-out area indicated by the dotted lines.

Use the following template as a guide for cutting a hole in a wall or furniture for the 4-gang size electrical box in order to install the transmitter.

light gray area represents the layout of the electrical box	(3.75" H x 7.38" W / 9.53 cm H x 18.75 cm W) against the rear of the TP T 468 front panel.
The

TP T 468 4-gang Cut-out Template

a wall box,	7.275" W /
To install the interface without	use the cut-out area (2.80" H x	7.11 cm H x 0.7 cm W) indicated by the dotted line.

cut-out area:	H x 19.25 cm W)	box.
indicates the	W / 10.03 cm	electrical wall
The dashed line	(3.95" H x 7.58"	for installing the

A-12 Extron TP Transmitters • Specifications, Accessories, and Part Numbers Extron TP Transmitters • Specifications, Accessories, and Part Numbers A-13