Extron electronic TP T 468 Installation and Operation, cont’d, 16- Installation features, TP T

Installation and Operation, cont’d

1

Computer Input connector — Connect a	10 5	1 6
computer video source to this 15-pin HD
female connector.	15	11

13

3

4

NO MONITOR

MONITOR

MONITOR H. SHIFT

INPUT

MIN/MAX

AUDIO

TP T 468

Input only sync signals, no video	Female
signals, on the sync pins (pins 13 and 14).

For component video, use the R (R-Y) and R return pins (pins 1 and 6), G (Y) and G return pins (pins 2 and 7), and B (B-Y) and B return pins (pins 3 and 8).

For S-video, use the R, R return (C-chroma), G, and G return (Y-luma) pins.

For composite video, use the G pin and the associated return pin. For additional genlocked video signals, use the R, B, and associated return pins.

2 1 14

5 15

12 10

Figure 2-16 — Installation features, TP T 468

Transmission of component video, S-video, or composite video on the computer video input requires that internal jumpers (TP T 15HD A and TP T 15HD AV) or a DIP switch (TP T 468) be reconfigured. See “Video jumpers,” or “Video DIP switch,” earlier in this chapter.

2

3

4

5

Audio input connector — Connect PC audio to this 3.5 mm, stereo jack. Wire the male plug as shown in figure 2-17.

Input only analog, line level, audio signals on the audio input connector.

Tip (L)

Ring (R)

Sleeve ()

Figure 2-17 — Audio input wiring

Buffered Local Monitor output connector — Connect a local monitor video cable to this 15-pin HD female connector.

ID bit switches (TP T 15HD A and TP T 15HD AV) — If a local monitor is installed, set both switches to off. If no local monitor is installed, set both switches to on.

DDSP switch — This switch turns on Digital Display Sync Processing, disabling sync processing for LCD projectors and other displays that cannot tolerate processed sync.

DDSP disables the horizontal shift control.

2-22 Extron TP Transmitters • Installation and Operation Extron TP Transmitters • Installation and Operation 2-23