System Configuration
This section describes the following:
• VNC 200 Web Interface
• Configuring a VNC 200 as an Encoder (Source)
• Configuring a VNC 200 as a Decoder (Display)
• Troubleshooting

VNC 200 Web Interface

Once all VNC 200 devices have been correctly set up for (and connected to) a network,
any further system configuration is achieved via the VNC 200 web interface. This contains
a number of pages which provide access to various system parameters.
TIP: This section provides step-by-step instructions for using the web interface and
is aimed at new users of the VNC 200 system. Advanced users may wish to
see Technical Data.
The web interface is “served up” by the VNC 200 device that was designated as
the controller during the network setup procedure (see “Setup and Connection
Procedure”). It can be viewed by any up-to-date web browser, running on a PC or a
laptop that is connected to the same network as the VNC 200 devices.
Suitable browsers include, but are not limited to:
• Microsoft® Internet Explorer (v6 and above)
• Firefox®, Mozilla® (v1.3 and above)
NOTE: Whatever browser is used, it must be configured to accept cookies and
be JavaScript-enabled. For further help on configuring your browser, see
“Browser Configuration”.

Accessing the web interface

1. Enter the IP address of the controller device into the address bar of the web browser,
for example, http://192.168.0.18. The following web page illustration appears in
the web browser.
VN-Matrix 200 Series • System Configuration 24