Figure 20. Configure Page
f Check that the Input Mode is set to auto. if not, see “Input Mode”.
g Check that the Current Mode shows the format of the connected source. If it does
not, see “Input Mode”.
h Check the Multicast Enable box if RTP multicast source streaming is required,
otherwise ensure this box is unchecked to enable RTP unicast.
TIP: If your source or local monitor uses EDID, you may need to look at these
settings, see “EDID options” and é in the previous diagram.
i Does the source have an audio channel?
No... Yes...
Encoder setup is complete, click the Save All tab.
If a local monitor is connected it should now be
displaying the source. If it is not, see “Source
Checkup.”
See “Additional Setup for
Audio”.
j Repeat this procedure (from step a) for each encoder in the system. To configure the
VNC 200 device as a decoder (display), see “Configuring a VNC 200 as a Decoder
(Display).”
VN-Matrix 200 Series • System Configuration 29