Extron electronic a b c, Operation, XTP T HDMI Front Panel Indicators, B Input indicators

Operation

After all transmitters, all receivers, and their connected devices are powered up, the system is fully operational. If any problems are encountered, verify that the cables are routed and connected properly. If problems persist, call the Extron S3 Sales & Technical Support Hotline. See the contact numbers on the last page of this guide for the nearest Extron office.

XTP T HDMI Front Panel Indicators

		INPUT
CONFIG	SIGNAL	HDMI AUDIO	AUDIO SIGNAL CLIP
	HDCP	ANALOG AUDIO
			XTP T HDMI

a b

Figure 12. XTP T HDMI Front Panel Features

APower LED — Lights when power is applied to the device from the power supply or remotely from an XTP Power Injector or XTP matrix switcher. There are two Power LED indicators, one on left side of the front panel and one on the left side of the rear panel.

BInput indicators

Signal LED — Lights when an active video signal is detected from the source. HDCP LED — Lights when the input signal is encrypted.

HDMI Audio LED — Lights when the HDMI audio input is selected. Analog Audio LED — Lights when the analog audio input is selected.

Audio Signal Clip LED — Lights when the analog audio input signal remains above -3 dBFS. The LED remains lit for 200 milliseconds after the signal falls below -3 dBFS.

XTP R HDMI Front Panel Indicators

	XTP		AUDIO
CONFIG	SIGNAL	HBR	BITSTREAM	LPCM
	HDCP	HDMI	S/PDIF	ANALOG
				XTP R HDMI

a b c

Figure 13. XTP R HDMI Front Panel Features

APower LED — Lights when power is applied to the device from the power supply or remotely from an XTP Power Injector or XTP matrix switcher, such as an

XTP CrossPoint. There are two Power LED indicators, one on left side of the front panel and one on the left side of the rear panel.

BXTP indicators

Signal LED — Lights when an active XTP input signal is received.

HDCP LED — Lights when the input signal is encrypted.

XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 13