Extron electronic h a b c, d e f g, XTP R HDMI Rear Panel Connectors, XTP R HDMI Connectors

XTP R HDMI Rear Panel Connectors

h a b c d e f g

POWER		SIG	LINK
12V
	1.0 A MAX

XTP IN

OVER XTP			OUTPUTS	RELAYS
	AUDIO		AUDIO
RS-232 IR		L	R	1	2
	ON					RESET

LAN Tx Rx G Tx Rx OFF HDMI + - + - S/PDIF

Figure 4. XTP R HDMI Connectors

AXTP connector — Connect a twisted pair cable to the RJ-45 connector labeled

XTP In on the receiver and to an XTP output port on another XTP device to receive all signals (see TP Cable Termination and Recommendations on page 9). This cable carries the following signal:

•Digital video

•Digital audio

•Bidirectional RS-232 and IR commands

•Remote power

•Ethernet communication

•System communication

The Link LED lights amber when XTP devices are connected and communication is established.

The Signal LED lights green when the receiver receives an active HDMI video signal or a test pattern from the transmitter.

ATTENTION:

•Do not connect this connector to a computer data or telecommunications network.

•XTP remote power is intended for indoor use only. No part of the network that uses XTP remote power should be routed outdoors (see Remote power on page 12).

BLAN connector — Connect a control device or device to be controlled to the transmitter for 10/100 Ethernet communication through this pass-through port. LEDs on the connector indicate link and activity status.

CRS-232 Over XTP port — To pass bidirectional serial, Infrared, or other control signals between XTP-compatible devices, connect a control device to the 5-pole captive screw connector. The port includes only the 3 poles labeled “RS-232.”

IR Over XTP port — To enable the ability to transmit and receive IR signals (up to 40 kHz), connect a control device to the 5-pole captive screw connector. This port includes only the 2 poles labeled “IR” and shares the ground pole with the RS-232 port.

RS-232 IR

Tx Rx G Tx Rx

RS-232 IR

Tx Rx G Tx Rx

NOTE: RS-232 and IR data can be transmitted simultaneously (see RS-232 and IR Communication on page 10 for wiring details).

DHDMI output — Connect a digital video display to the female HDMI connector (see HDMI Audio Switch on page 14 to select local audio output options). It can accept HDMI, DVI (with an appropriate adaptor), or DisplayPort video signals.

NOTES:

•Maximum cable length is 15 ft.

•Use Extron LockIt lacing brackets to secure HDMI connectors to the device (see HDMI LockIt on page 8).

•Video input from a DisplayPort source must be a dual mode DisplayPort source.

XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 6