Extron electronic XTP R HDMI, XTP T HDMI manual HDMI Audio Switch, Edid, C Audio indicators

CAudio indicators

HBR LED — Lights when the input audio signal is high bit rate audio.

Bitstream LED — Lights when the input audio signal is a Dolby® Digital, DTS® audio format and 2-channel Dolby.

LPCM LED — Lights when the input audio signal is LPCM-2Ch.

HDMI LED — Lights when the input audio format is multi-channel, LPCM-2Ch, or Hi-Def audio.

S/PDIF LED — Lights when the input audio format is multi-channel (except HBR), or LPCM-2Ch,

Analog LED — Lights when the input audio format is LPCM-2Ch.

HDMI Audio Switch

The XTP T HDMI and XTP R HDMI have an HDMI audio switch that mutes the embedded audio on the related HDMI connector. On the XTP T HDMI, the audio switch mutes or enables the audio on the HDMI loop-thru connector. On the XTP R HDMI, the audio switch mutes or enables the audio on the HDMI output connector. The LED next to the switch lights when HDMI audio is enabled.

AUDIO ON

OFF

Move and hold the rear panel HDMI audio switch up for about 1 second to enable embedded audio on the associated HDMI connector, or move and hold the HDMI audio switch down for about 1 second to disable embedded audio on the associated HDMI connector. The switch returns to the middle position after it has been released so the device can continue to be controlled through SIS commands.

EDID

NOTE: In matrix applications, EDID on the transmitter is assigned by the matrix switcher using the XTP System Configuration Software.

The XTP T HDMI can record and save EDID in a user memory location on the transmitter. EDID can come from the loop-through display on the transmitter or the output display on the receiver (default). Connect a host device to the XTP transmitter for EDID control (see SIS Configuration and Control on page 16 or XTP System Configuration Software on page 23).

XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 14