Remote power
The XTP HDMI transmitter and receiver can be powered remotely through an XTP Power Injector or through an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network that uses XTP remote power should be routed outdoors.
Power injector
To power XTP HDMI transmitters and receivers remotely with an XTP Power Injector, power one device locally (see Local power on page 11) and connect an XTP Power Injector to the XTP cable run along the XTP ports (see the XTP Power Injector User Guide for more installation information).
NOTE: The power injector provides remote power up to 330 feet with a CATx cable with 24 AWG wire.
12 V Local Power
Supply
|
|
|
| LAN |
| XTP |
| OUT | CATx Cable |
OVER |
| XTP |
AUDIO |
|
+ | − |
AUDIOON | + | − |
OFF |
|
|
INPUTS
HDMI
| XTP | Remote |
| PWR | Power |
Extron | XTP |
|
|
| |
XTP PI 100 |
|
|
XTP Power |
|
|
Injector |
|
|
HDMI
Extron
XTP T HDMI
XTP Transmitter
Player
| AUDIO |
|
XTP | ON | HDMI |
OVER | OFF |
|
LAN
IN
XTP
Extron
XTP R HDMI
XTP Receiver
RELAYS
|
|
| OUTPUTS |
| AUDIO |
|
|
|
| - | S/PDIF |
| + |
| |
+ | - |
|
|
HDMI
Display
Figure 11. Typical Point-to-Point Application with Remote Power
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to connected XTP endpoints (refer to the user guide of the XTP matrix switcher for more details). To manage available power from the XTP matrix switcher, use the XTP System Configuration Software (see XTP System Configuration Software on page 23).
XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 12