Extron electronic XTP T HDMI Audio Output Overview, Reset Modes, Audio Input Format, Hdmi, S/Pdif

Audio Output Overview

By default, the XTP HDMI transmitter prioritizes embedded digital audio over analog audio. Use SIS commands or the XTP System Configuration Software to manually select the audio input (see SIS Configuration and Control on page 16 or the XTP System Configuration Software on page 23).

		Audio Output
Audio Input Format	HDMI	S/PDIF	Analog
LPCM up to 7.1, 24 bit, 192 kHz	X	X	X
Multi-channel PCM	X
Dolby Digital 2/0	X	X
Dolby Digital 2/0 Surround	X	X
Dolby Digital 5.1	X	X
Dolby Digital EX	X	X
Dolby Digital Plus	X
Dolby TrueHD	X
DTS 2 Channel	X	X
DTS Digital Surround 5.1	X	X
DTS-ES Matrix 6.1	X	X
DTS-ES Discrete 6.1	X	X
DTS-HD	X
DTS-HD Master Audio	X

NOTE: The transmitter uses a black signal to simulate a 720p or 1080p, 50 Hz or 60 Hz signal so audio can be passed without video.

Reset Modes

Use the recessed Reset button on the rear panel of the transmitter or receiver to return the device to default settings or to restore factory-shipped firmware.

RESET

			Reset Mode Summary
	Mode	Mode Activation	Result	Purpose/Notes
	1	Hold the recessed Reset	The device reverts to the	Use mode 1 to roll back to factory
		button down while applying	factory default firmware.	firmware for a single power cycle
		power to the device.		if an incompatibility issue arises.
Reset
		NOTE: After a mode 1	NOTE: If you do not want
		reset, update the device	to update the firmware or
Factory
		with the latest firmware	perform a mode 1 reset
		version. DO NOT operate	by mistake, cycle power
		the firmware version that	to the device to return the
		results from this mode	firmware version running
		reset.	prior to the reset.

XTP T HDMI Transmitter and XTP R HDMI Receiver • Installation 15