Fender SRM 8302 manual Input / Output Connections, BASIC SETUP OF YOUR SRM 6302

INPUT / OUTPUT CONNECTIONS BASIC SETUP OF YOUR SRM 6302 / 8302

The SRM 6302 / 8302 has a variety of connectors on its input / output panels. Below is a chart listing the various types and their pin outs.

Jack	Style	Connection	Pin Out
MIC	XLR	Balanced	Pin 1 = GND
INPUTS	Female	Input	Pin 2 = POS
			Pin 3 = NEG
LINE	1/4"	Balanced	Tip = POS Signal
INPUTS	TRS	Input	Ring = NEG Signal
			Sleeve = GND
MAIN,	1/4" TS	Unbalanced	Tip = Signal Output
MONITOR,		Output	Sleeve = GND
EFFECTS
OUTPUTS
FOOT	1/4" TS	Switch	Tip = Signal
SWITCH			Sleeve = GND
PA 1,	1/4" TS	Unbalanced	Tip = Input Signal
PA 2,		Input	Sleeve = GND
EFFECTS
INPUTS
TAPE	Dual	Unbalanced	Inner Ring = Signal
IN / OUT	RCA	Input /	Outer Shell = GND
		Output
PA 1,	1/4" TS	Speaker	Tip = Signal
PA 2		Output	Sleeve = GND
OUT

Before using the SRM 6302 / 8302, please read and follow the steps listed below:

1.IMPORTANT Heed all safety warnings when operating the SRM 6302 / 8302.

2.Make sure the power switch is in the OFF position and all volume levels are in the 0 position.

3.Next, plug the supply cord into a power source with the correct voltage.

5.Connect the speaker cables from the SRM 6302 / 8302 PA out jacks to the input jacks of the speaker cabinets.

6.Connect the cord(s) from any outboard gear, microphones or other signal source(s) to the appropriate input jack(s) on your SRM 6302 / 8302's.

7.First, turn all outboard gear, instruments and other equipment ON, then the SRM 6302 / 8302.

8.Increase volume controls and effects level controls to their desired levels, listening for feedback or ringing.

9.When shutting down the SRM 6302 / 8302, turn OFF the SRM 6302 / 8302 first then any additional outboard gear, instruments or other equipment.

For more detail on setting up your SRM 6302 / 8302, please refer to the diagrams on pages 10 thru 13.

8